V
Workshop on Environmentally Benign Manufacturing
The Research Group on Environmentally Benign Manufacturing, one group of the Nucleus of Advanced Manufacturing, is promoting the V Workshop on this issue. It will be held on November 25th, 2004, at the São Carlos School of Engineering, University of São Paulo (EESC-USP). The subject, Life Cycle Engineering, will count with the valuable contribution of Prof. Dr.-Ing. Günther Seliger and Dipl.-Ing. Carsten Franke both from the Collaborative Research Center 281 from Technical University of Berlin
Workshop Objectives
Agenda
7:30 – Registration
8:00 - Welcome Speeches
·
Prof. Dr. Francisco Antonio
Rocco Lahr
o
Director: São Carlos School
of Engineering – University of São Paulo
·
Prof. Dr. Sérgio Mascarenhas
o
Coordinator: Institute of
Advanced Studies – University
of São Paulo
·
Prof. Dr. João
Fernando Gomes de Oliveira
o Coordinator: Institute Factory of Millennium
o
Coordinator: Group on Environmentally Benign Manufacturing
Global Sustainability - A Future Scenario Speaker of the Collaborative Research
Center 281: Disassembly Factories for the Recovery of Resources in Product
and Material Cycles Professor at the Institute for Machine
Tools and Factory Management, Technical
University Berlin 9:00 – Prof. Tit. João Fernando Gomes de Oliveira. Coordinator: Institute
Factory of Millennium Coordinator: Group
on Environmentally Benign Manufacturing
9:30
– Science and Technology Ministry Lea Contier de Freitas: Technology and Computer science Politics
Secretariat 10:00 – Ministry of Development, Industry and International Trade Marcos Otávio Bezerra Prates: Production Development Secretariat 10:30 – Coffee Break 11:00
– Environmental Ministry To be confirmed 11:30 – Prof.Dr. José Galizia Tundisi President:
International Institute
of Ecology 12:00 – Discution 12:30
– Lunch 14:00 – Dipl.-Ing. Carsten Franke
Implementation of the Directive on WEEE in Germany - Economical,
Technological and Environmental Challenges Manager of the Collaborative Research
Center 281: Disassembly Factories for the Recovery of Resources in Product
and Material Cycles Research Engineer at the Institute
for Machine Tools and Factory Management, Technical University Berlin 14:30 – Presentation of the potential partners and their competencies in Sustainable Product Design and Life Cycle Engineering
Brazilian Network 16:00 – Coffee Break 16:30 – Luis Cesar Stano
Coordinator: Health, Safety and Environmental, Petrobras 17:00 - Paulo Vodianitskaia Environmental Coordinator: National Association of Manufacturers
of Electric and electronic products
17:30 - Eduardo Vaz
Manager: Consumer Goods Marketing, Xerox 18:00 – Discussion
18:30 – Closing
|